The sea hood is a curious feature on the deck of a sailboat. You can picture it as the shell of  a turtle and the sliding hatch as its head, coming in and out. When open the hatch slides underneath the sea hood, when closed it comes all the way out.

The sea hood covers and protects the opening between the cabin top and the hatch deflecting waves that otherwise will put the hatch under siege making it a very good feature for a blue water boat. Water is so good in finding its way into things that trying to stop it requires the help of multiple agents, and here the sea hood comes into the game.

On Tranquility, our 50 years old Columbia 29 mki, the sea hood is built in solid teak, like the rest of the companionway. Functioning as partial beams the longitudinal elements of the structure strengthen the deck, which on Tranquility is fiberglass laminate with no core, and so it’s a bit springy. Beside being bulky heavy and complex, a fully restored watertight seahood contributes to the sturdiness of a boat.

The project steps are very similar to the ones I described in the sliding hatch post, with the difference that I had to work on the deck instead this time.

At first I worked caulking all the gaps around the sea hood, using Teak Decking Systems product. The effort has the objective to avoid that water running on deck would sip underneath the wood.

After that I proceeded rebuilding the plywood support. Again, I used 1/4 inch plywood because the sea hood has a curve and thicker plywood won’t allow to bend as easily. To reach the desired thickness and strenght I laminated two pieces one on top of the other.

To save some expensive caulking and to make the job easier I routed 1/8 inch slot into the teak strips with a table router I borrowed from Fernando. Fernando is a good friend of mine and a talented guitar maker, check out his work on his website.

I had to shuffle around the teak strips to find the best match. For how hard I tried to get the most precise fit, the curved surface put some challenges to this job.

Such an asymmetrical shape required custom ideas to cajole the pieces into shape. In this case some hevy weight and flexible plywood strips did the job.

I proceeded filling the slots using the same caulk product. After taping the wood to make an easier clean-up, I used a cheap caulking gun (still on a budget…) to fill the slots. Following with a spatula I pressed the caulk hard down into the slots working two strips at the time and removing the tape along with the progress.

A final sanding to remove excess caulk left a smooth surface. I then washed the teak thoroughly with a solution of water (75%) and bleach (25%) plus a couple of tablespoon of Sodium Triphosphate and finally applied three coats of Semco Teck Sealer.

I am glad another piece of the companionway is completed. It’s amazing how complicated it is. With components sliding into each others and pieces that have to be reinstalled in the correct sequence it resembles a puzzle game and I am very glad there are less and less pieces to get to the final picture.